The introduction of multi-axis die stations by Martin Pultrusion has proven to be one of the most beneficial advancements in
pultrusion technology over the past decade. The ability for an operator to mechanically offset material induced warps and
bows by simply changing the axis of the die during processing has proven to dramatically reduce scrap rates, improve up-time
and better maintain the structural integrity of profiles. Multi-axis die stations are used extensively throughout
the fenestration market with proven economic success.
Standard
Durapul die stations come standard with non-eccentric tube die mounts which reduce thermal drain and also allow for independent front to back height adjustments.
Durapul die stations come standard with non-eccentric tube die mounts which reduce thermal drain and also allow for independent front to back height adjustments.
4-Axis
Multi-axis movement of the die allows an operator to easily offset warp and bow during processing. The ability to change the axis of the die during processing has proven to dramatically reduce scrap rates.
Multi-axis movement of the die allows an operator to easily offset warp and bow during processing. The ability to change the axis of the die during processing has proven to dramatically reduce scrap rates.
Heat Conrol
Heated Die Stations can be built to supply anywhere from 1 to as many as 30 heat zones. Each station is equipped with a PLC touch screen which is programmed to control each zone independent of the pultrusion machine.
This piece of equipment is an economical way for pultruders to upgrade to more efficient plate heaters.
Heated Die Stations can be built to supply anywhere from 1 to as many as 30 heat zones. Each station is equipped with a PLC touch screen which is programmed to control each zone independent of the pultrusion machine.
This piece of equipment is an economical way for pultruders to upgrade to more efficient plate heaters.
